HD BE Elevator Control Cards

Hedefsan HD BE Elevator Control Cards

+ Compatible EN81-20

+ Simple Activation & Installation

+ Programmable inputs and outputs

• Compatible EN81-20

• Assİgned and programmable outputs

• Door opening leveling

• Adjustment of parking floor inside the car

• 3 m/s speed support

• Exit to next floor

• Ability to work up to 4 groups of lifts

• Call redirection in group operation

• 16 standard stops, up to 32 floors

• Call buttons and call lamps need only one shared wire.

• Programming with password protection, PUK code protection against unauthorized using.

• Ail parameters can be simply adjusted via b uiilf in LCD screen and program buttons.

• Last 20 errors including information of floor can be traced on LCD screen.

• In stand-by mode the operation time of the lift after the last maintenance (as day and hour) is screened on LCD screen.

• Adjustable maintenance time, warning when it is the maintenance time on LCD screen,

• With built-in panel terminals, simple and fault free installation, saving in time and control panel terminals.

• Over-load function

• Short-circuit protected display outputs which can be adjusted to every floor.

• Gray/Binary code converter board

• Outputs for direction arrows, Out Of Service signal and busy signal' via SA relay, signal common input for these outputs.

• Adjustable park floor and duration of parking time.

• Pulse bi-stable switches for car position sensing

• The car position information with 4 encoder inputs

• Optional, when the electric power is on again, moving the car to the first floor.

• Warning signal on LCD screen when the door is open or when no stop signal more than the adjusted time.

• Adjustable car lamp time, lock wait time, wait at floor time, max high speed time and max low speed time.

• Door opening signal (AUTO) selection type of working related to direction arrows,

• Function of manual movement at low speed by using program buttons.

• Selection of the first target floor on outside displays when each floor pass ng,

• At revision mode selection of the movement to limit sw!tches and exact floor level.

• Selection of the floor with the full automatic door for the lifts which has only one door is full automatic

• Electronic controlling of phases, phase order and PTC (Motor temperature) shown faults about these controls via LCD screen.